Cosmic Water Conditioner Installation Guide

• If your home design contains a bore well that pump the water to the overhead tank, then it is recommended to install the unit at the sump of the overhead tank. If by any means your water tank doesn’t have a sump then it can directly be installed between the bore to the overhead tank.

• The insertion of a Cosmic hard water softener can be done either on the pump outlet or at the tank inlet all depending on the flow of water.

• There are different aspects to install to this cost-effective hard ward softener in your homes. If the hard water damage is at a large scale then you can have units installed to each bathroom & kitchen. However, if the damage is not big then you can have it installed in your main supply water line for soft water in the whole house.

water conditioner installation
  • Step 1
  • Step 2
  • Step 3
  • Step 4
  • Step 5
  • Product Requirement Calculation

Locating the position for the installation of Cosmic Hard Water Conditioner

Marking the length of the Cosmic Hard Water Conditioner

Cut down to remove the measured length from the existing pipeline

  • Slowly insert the Cosmic Hard Water Conditioner after cutting the main water supply

Get Soft Water, instantly, smoothly, and naturally 

Individual House

For 2-6 Member X 1 No's 1000 LPH

For an Apartment

4-6 Flats - 2 to 3 No's 1000 LPH

Every 2 to 3 No's Water conditioner requires 1 No of 2 Inch Pre Filter